The last step is to type in your network’s password. If you did take a guess, are you ready to find out the answer? So here it is. So have you taken a guess? If not no worries, it was just to make the process a bit more exciting. If you couldn’t guess, then proceed to read the next paragraph. It’s not hard to guess what is the thing that you’ve got to do after selecting the Wi-Fi network you want to connect your smart hub with, so take a moment to guess what it is. Step 5: Now there is just one thing you’ve got to do and if you don’t do it right, everything else would have been for nothing. Plus, if you’ve got multiple Wi-Fi networks to click on the one that you want to connect your Vivint smart hub with □ Make sure to click on the one that’s yours, otherwise, it won’t work. Step 4: You’ll be presented with the names of all the Wi-Fi networks available in your area. No matter where it is located on the screen. Click on the one called Connectivity.Īfter clicking on Connectivity, you’ll be shown multiple options again. On this page, there are also going to be multiple options. Step 3: After entering the pin, you’ll be taken to a new page. Instead, click on the option called General, no matter where it is located.Īfter clicking on General, you’ll be asked to enter a 4-digit pin. The General option might not be located at the same spot on your panel, in that case, don’t click the third option from the bottom. The third option from the bottom would be called, General. Step 2: Clicking on the menu will present multiple options on the screen of your panel. Hover over them and click on the one that says Menu. Have you opened the homepage yet? Awesome, now do this. Step 1: The first step you’ve got to take to connect the Vivint smart hub to the Wi-Fi is to go to the homepage of your Vivint panel. So are you ready to connect the Vivint smart hub to the Wi-Fi so you can reap some awesome benefits? If you’re not, go take a bath or whatever is it that you’ve got to do and then come back and follow these steps. It’s time to connect the Vivint smart hub to Wi-Fi. Now that the secondary router is attached and ready to work, it’s time to take the next step. So after 5 minutes, turn on the power outlet. ![]() This process wouldn’t take any longer than 5 minutes. Turn on the power source and wait for a few minutes so the power source can do the booting and start broadcasting wireless networks. Step 3: Now it’s time to take the final step for connecting both routers. The original router and the secondary one (modern or primary router). Make sure the ethernet cable is connected firmly on both ends. Step 2: Now it’s time to connect the ethernet cable with the outport of the primary or modern router. Run it through the existing primary router or the existing modern router.Įither will do so just use the one that has an outport. After you’ve got an Ethernet cable, do this. Step 1: The first thing you’ve got to do is grab an ethernet cable.
0 Comments
Leave a Reply. |